MacDon D60 Draper Headers - Manual (Page 104)

SECTION 8. MAINTENANCE AND SERVICING
Form 169441 102 Revision B
L
d. Loosen two bolts (H) on sickle drive mounting
bracket.
e. Turn adjuster bolt (J) to loosen the two V-belts
(K), and remove belts.
f. Remove bolt in plate
(L) in left endsheet at
wobble box, and
remove the plate.
This provides
clearance between the
pulley and endsheet
for the belt when it is
removed.
g. Slip timing belt off
wobble box pulley, and route the belt between the
wobble box pulley and the endsheet.
h. Remove belt from drive pulley.
8.7.9.1.3 Installation - Left End Timing Belt
a. Locate timing belt (M) onto drive pulley (N).
b. Route belt between the wobble box pulley (O)
and the endsheet, and locate on wobble box
pulley and over idler (P).
NOTE
When installing new belt, never pry belt
over pulley. Be sure adjusting device is
fully loosened, then tension belt.
c. Position V-belts (K) onto drive pulleys.
d. Turn adjuster bolt (J) to move drive motor until a
force of 12 lbf (53 N) deflects V-belts (K) 1/8 in.
(3 mm) at mid-span.
e. Tighten the two bolts (H) on drive mounting
brackets.
(continued next page)
J
H
K
J
H
K
N
M
O
P