MacDon D60 Draper Headers - Manual (Page 54)

SECTION 7. OPERATION
Form 169441 52 Revision B
f. Check that divider does not move laterally.
Adjust bolts (J) as required to tighten divider, and
remove lateral play when pulling at divider tip.
g. Replace endshields.
D50
b. Open endshield.
c. Remove bolt (A), lock-washer, and flat washer
from inside of end sheet.
d. Lift crop divider to disengage lugs (B) from
endsheet.
e. Position crop divider as shown by locating lugs
(B) in holes in endsheet.
f. Lift forward end of divider and re-install bolt (A),
lock-washer, and flat washer. Tighten bolt.
g. Check that divider does not move laterally.
Adjust bolts (C) as required to tighten divider and
remove lateral play when pulling at divider tip.
h. Close endshield.
J
A
B
B
A
C