MacDon D60 Draper Headers - Manual (Page 133)

SECTION 8. MAINTENANCE AND SERVICING
Form 169441 131 Revision B
8.9.11 REEL SPEED SENSOR
CAUTION
To avoid bodily injury from fall of raised reel,
always engage reel props before going under
raised reel for any reason.
WARNING
Stop engine, and remove key before making
adjustments to machine. A child or even a pet
could engage the drive.
To adjust and replace the self-propelled
windrower reel speed sensor, proceed as follows:
a. Removal
1. Disconnect sender wire (A).
2. Remove nut and bolt (B) attaching sender to
support.
3. Remove sender (C).
b. Installation
1. Position sender (C) on support, and install
bolt (B) and nut.
2. Connect sender wire at (A).
3. Adjust clearance between sensor and driven
sprocket (D) to 0.080 - 0.160 in. (2 - 4 mm)
by bending support.
B
A
C
D
C
0.080 - 0.160 in
(2 - 4 mm)