MacDon D60 Draper Headers - Manual (Page 47)

SECTION 7. OPERATION
Form 169441 45 Revision B
5. Lift the aft end of the cylinder out of support
assembly, and retract the cylinder so that
cylinder center port fitting (K) engages the
support assembly.
NOTE
Loosen a hose fitting to allow
movement of cylinder rod. Be sure to
re-tighten fitting after cylinder
installation.
6. Re-install forward support plate (J) with bolts
(H).
7. Re-position hoses, and re-install shield (E)
with bolts (D).
8. Position hoses inside shield ,and install bolt
and nut (C).
9. Re-install aft support plate (G) with bolts (F).
c. Re-position right arm cylinder (Double Reel) as
follows:
1. Remove bolts (L) that secure aft plate (M),
and remove the plate.
2. Remove bolts (N) so that front support (O) is
free to move up.
3. Lift the aft end of the cylinder out of support
assembly, and retract the cylinder so that
cylinder center port fitting (P) engages the
support assembly.
(continued next page)
P
O
M
K
J
G
H
F G
E
CENTER ARM - AFT
D
C
RIGHT ARM - DOUBLE REEL
L
M
RIGHT ARM - DOUBLE REEL
N
O