Brother Fax-1020Plus - Manual (Page 149)

10-24
MESSAGE MANAGER MODE SETTINGS (Only for FAX 1030 Plus)
THE DISPLAY WILL SHOW: KEYS TO PRESS
G) REMOTE RETRIEVAL
What Is Remote Control Access?
When you leave your home or office, you can turn on your Message Manager to receive
voice and/or fax messages. But if you would like to deactivate the Message Manager or
activate certain Message Manager features you can control and program your fax by remote
control. You can call your fax from any touch tone phone, enter your remote control code,
followed by programming commands.
Setting the Remote Access Code
The initial setting for the remote control code on your new fax is “159*”.
09/12 15:25 FAX
1.TEMP.SETTINGS
8.SETUP TAD
4.REMOTE ACCESS
ACCESS CODE:159*
ACCESS CODE:160*
4.REMOTE ACCESS
1. Press Menu .
2. Press 8 .
3. Press 4 .
4. Enter a three digit number 000 to
998 . The last digit, an asterisk, can
not be changed.
Example:
160 * * * * *.
The three digit number must not be
the same as the remote activation
code. (See chap. 7.)
5. Wait for two seconds.
6. Press Stop to exit.
Helpful Hints
Change the remote control code and use it as a “secret password” to limit access to your Message
Manager. (Avoid using the same number as your emergency services).
When you use the Remote Access Code, you must press all four keys (three-digit number plus *).