Remote control commands – Brother Fax-1020Plus User Manual
Page 123
9-6
REMOTE FAX OPTIONS - CHAPTER 9
Remote Control Commands
You can control your fax machine with the following remote control commands.
Remote access command
If you hear one long beep, the change is accepted. If you hear three
short beeps, you cannot change it because the conditions (ex. registering
fax forwarding) have not been completed. You can register your fax
forwarding number by using 4. FAX FWD NO. Once you have
registered the number, the machine will automatically turn to “FAX
FWD:ON” mode. Then, receive a Memory Status List by entering 961.
Check the List to make sure the Fax Forwarding number you registered
is correct. Then enter the confirmation command 955. Now the machine
will start Fax Forwarding.
You can set FAX STORAGE ON or OFF.
You must use a remote fax machine in order to receive a List or stored
fax message(s).
If you hear one long beep, you can erase fax message(s) from the
memory.
You can check whether your fax machine has received any fax
message(s). If yes, you will hear one long beep. If no, you will hear
three short beeps.
If you hear one long beep, you can change the answer mode. If you
hear three short beeps, you cannot change it.
After a long beep, you can exit remote control.
Detailed operation
95
Changing Fax Forwarding
setting
1 OFF
2 Fax forwarding
4 FAX FWD No.
5 FWD NO. CONFIRM
6 FAX STORAGE ON
7 FAX STORAGE OFF
96
Retrieve FAX
1 Memory Status List
2 00
Retrieve all FAX
2 “MSG No.” 00
Retrieve by MSG
number
3 Erase FAX in the
memory
97
Check the receiving status
1 DOC
98
Change Answer Mode
1 TAD
2 F/T
3 FAX
90
Exit