Brother Fax-1020Plus - Manual (Page 132)

10-7
MESSAGE MANAGER MODE SETTINGS (Only for FAX 1030 Plus) - CHAPTER 10
The 3 Basic Steps to Turn the Message Manager Mode On
You can ensure you receive messages by following these three steps.
1. Setting the Message Store.
2. Recording the Outgoing Message (TAD OGM).
3. Activating the Message Manager Mode.
Setting the Message Store
Setting the Message Store is the first step in turning on the Message Manager Mode.
Before you set the Message Store, make sure you carefully read the “Mode Settings at a
Glance”. If you are using the Voice-on-Demand option, it is a good idea to set VOICE mode
to ON. Then, if a caller does not enter a command during the Message Manager Plus OGM,
the caller’s message will still be stored in the flexible memory for VOICE messages. Once
you decide the mode that best suits your needs, follow the steps below.
KEYS TO PRESS THE DISPLAY WILL SHOW:
1.TEMP.SETTINGS
8.SETUP TAD
1.MESSAGE STORE
DOC:OFF
SELECT { } & SET
DOC:ON
VOICE:ON
SELECT { } & SET
VOICE:ON
1.MESSAGE STORE
1. Press Menu .
2. Press 8 .
3. Press 1 .
4. Press Z (left arrow) or X (right
arrow) repeatedly to select ON or
OFF.
Example: DOC:ON.
5. Press Set .
6. Press Z (left arrow) or X (right
arrow) repeatedly to select ON, OFF
or EXT.
Example: VOICE:ON.
7. Press Set .
8. Press Stop to exit.