beautypg.com

Maintenance (engine), Air filter dust indicator, Drive belt tension – Multiquip AP6 Series User Manual

Page 55: Drive belt inspection

background image

AP6/AP8 SERIES TRASH PUMPS • OPERATION AND PARTS MANUAL — REV. #0 (06/11/14) — PAGE 55

5. To clean the main element (paper air filter) as

referenced in (Figure 50), tap the filter element

several times on a hard surface to remove dirt, or blow

compressed air from the inside out (not to exceed 30

psi (207 kPa, 2.1 kgf/cm

2

).

Figure 50. Air Filter

6. Replace the element if it is damaged or excessively

dirty.

7. Clean the inside of the dust pan.
8. Reinstall the element or if equipped, the precleaner

over the paper air cleaner element.

9. Reinstall the air cleaner dust pan and secure the

latches.

PRIMARY

AIR FILTER

ELEMENT

AIR FILTER

INDICATOR

BLOW COMPRESSED

AIR FROM THE

INSIDE OUT

DUST PAN

EVACUATOR

VALVE

AP6

T

O

P

AP8

SECONDARY

AIR FILTER

ELEMENT

PRIMARY

AIR FILTER

ELEMENT

NOTICE

DO NOT use excessive air pressure or the paper air

filter element will be damaged and will need to be

replaced. The filter can be cleaned and reused for up

to six times if properly cleaned. Replace air filter if rips

or tears are detected while cleaning.

NOTICE

DO NOT run the engine with the air cleaner removed

or without an element.

MAINTENANCE (ENGINE)

Air Filter Dust Indicator

The air filter indicator (Figure 51) is attached to the air filter.

When the air filter element is clogged, air intake restriction

becomes greater and the air filter indicator signal shows

RED. When indicator is red, replace filter immediately. After

changing the air filter, press the air filter indicator button

to reset.

Figure 51. Air Filter Dust Indicator

Drive Belt Tension

A slack drive belt may contribute to overheating, or to

insufficient charging of the battery, adjust drive belt in

accordance with the John Deere Operator's manual

Drive Belt inspection

Inspect the drive belt (Figure 52) for damage and wear.

Horizontal (across the belt) cracks are acceptable. Vertical

(direction of belt ribs) cracks that intersect with horizontal

cracks are not acceptable.

Figure 52. Drive Belt Inspection

If the drive belt is frayed, punctured, or material is missing

DO NOT use drive belt.

NOTICE

The air filter should not be changed until the indicator

reads “

RED”. Dispose of old air filter. It may not be

cleaned or reused.

PUSH BUTTON TO RESET

25 INCHES H O

2

6.23 kPa

NO

NO

This manual is related to the following products: