Brother HL-1260 - Manual (Page 70)

IV - 22
1.30 Transfer Unit
(1) Loosen a screw.
(2) Release the 3 right hooks, (see Figure 4.57) lift the right part of the unit ( A ) and slide it to
the right ( B ) to take off the left part from the main chassis L. Remove the transfer unit from
the body by lifting the former.
(3) Open the transfer base hook and take off the left bearing (white) from the hook ( A ). Lift the
left side ( B ), slide it to the left ( C ) and take off the roller shaft from the right bearing (black) ( D ).
(4) Remove the transfer roller assy.
Caution : Do not touch the sponge rubber roller when replacing the transfer roller (the roller with
hand grease or clasped too strongly may result in poor printing quality).
Figure 4.57
Figure 4.56
Main chassis L
D
Transfer base assy
C
B
A
Transfer roller assy
3 Hooks
Screw
Transfer unit
Right
A