Brother HL-1260 - Manual (Page 306)

CHAPTER 4 CONTROL PANEL
4–27
✒ Notes
•
When another pen is selected, the display shows the selected pen with
the number after “SIZE’ or “GRAY.”
• Whichever resolution, 300 or 600 dpi, you have selected, the pen size
takes effect in units of 300 dpi.
■ Character Set
When you select “CHARACTER SET,” you can select the standard and
alternate character sets used in the HP-GL emulation mode.
Enter the sub-setting menu and select the menu for the standard or alternate
character set with the ▲ or ▼ switch:
To set the standard character set, select the following message:
STANDARD SET
or
To set the alternate character set, select the following message:
ALTERNATE SET
Then press the SET switch to show the following message:
ANSI ASCII *
Change the character set with the ▲ or ▼ switch and make the selection
effective by pressing the SET switch. For specific character sets, see
“SYMBOL/CHARACTER SETS” in Appendix.