Brother HL-1260 - Manual (Page 162)

VI - 10
Table 6.2 Error Messages
Error Message Meaning Action
Press the CONTINUE
switch to start printing the
next page. Data which
overran the print area on
the page cannot be
printed. Check your page
protection setting with the
MODE switch. Setting
page protection to the
correct size could solve
this problem. If printing at
600 dpi, you may need to
add optional SIMM
memory.
Press the CONTINUE
switch to resume printing.
Data lost in overflow
cannot be printed.
Press the CONTINUE
switch to resume printing.
If the same error should
occur after you press the
CONTINUE switch, turn
off the printer. Wait a few
seconds, then turn it on
again . Reduce the input
buffer size. Turn off
”KEEP PCL.” Add SIMM
memory with power off.
Download font and the
font saved in the HDD
card might cause the
error, for it occupies the
same work area as the
RAM. Memory expansion
is recommended in that
case.
When the serial interface
is used, check the
communications
parameters such as baud
rate, code type, parity,
and handshake
protocols. When the
parallel interface is used,
check the interface cable
connection.
Turn off the printer. Wait
a few seconds, then turn
it on again. See M-17.
Print overrun
Input buffer overflow
Work memory overflow
Error in the
communications circuit
Error in communication
with the engine controller
31 PRINT OVERRUN
32 BUFFER ERROR
34 MEMORY FULL
40 LINE ERROR
41 PRINT CHECK