Brother HL-1260 - Manual (Page 103)

VI - 26
7. STATUS MESSAGE LIST
Table 6.2 Operator Call Messages
Operator Call Message Meaning Action
CHECK XX TRAY
12 COVER OPEN
13 JAM XXXXXX
14 NO CARTRIDGE
XX NO CASSETTE
16 TONER EMPTY
XX LOAD PAPER *****
SIZE
18 MANUAL FEED *****
SIZE
19 CHECK FONT
20 FONT REMOVAL
27 NO DX UNIT
27 NO DX TRAY
27 DX OPEN
The paper cassette (XX
is MP/T1/T2) is out of
paper.
The upper cover of the
printer is open.
Paper is jammed in the
printer. XXXXXX is
TRAYS/INSIDE/REAR/
DUPLEX.
The toner cartridge is not
installed in the printer.
The paper cassette is not
installed. XX is T1/T2.
The printer has almost
run out of toner: you may
print another 30 to 100
pages. (The ALARM
lamp lights at the same
time.)
The wrong size of paper
was loaded in the paper
cassette XX. XX is MP/
T1/T2. (The message
appears alternately to
show a particular size.)
The printer requests you
to load paper manually.
(The message appears
alternately to show a
particular size.)
An error occurred in the
optional font cartridge/
card.
The font cartridge/card
was removed while the
printer is on-line.
The duplex unit is not
installed with the printer
when the duplex printing
mode is selected.
The duplex paper guide
tray is not installed in T1
when the duplex printing
mode is selected.
The cover of the duplex
unit is open.
Load a stack of paper
into the cassette. See
M-7.
Close the cover. See
M-6.
Remove the jammed
paper from the indicated
area. See M-10.
Install a toner cartridge.
See M-8.
Install the paper cassette.
Remove the toner
cartridge, rock it several
times at 45°, and install
it again. Or replace the
toner cartridge with a new
one. See M-9.
Load the requested size
of paper in the paper
cassette, or load it on the
manual feed tray and
press the FORM FEED
switch.
Load the requested size
of paper on the multi-
purpose tray and press
the SEL switch.
Turn off the printer,
and reinstall or replace
the optional font
cartridge/card.
Turn off the printer,
install the font cartridge/
card, and turn on the
printer. The
CONTINUE switch will
allow you to temporarily
ignore this message.
Install the duplex unit
correctly.See the DX-
1200 user’s guide.
Install the duplex paper
guide tray into T1. See
the DX-1200 user’s
guide.
Close the cover. See the
DX-1200 user’s guide.