Brother HL-1260 - Manual (Page 322)

CHAPTER 4 CONTROL PANEL
4–43
You can turn on or off the auto form feed in this mode menu as follows:
Display Message Auto Form Feed
AUTO FF=OFF Turn off the auto form feed. You need to
press the FORM FEED switch every time
data remains in the printer’s memory.
(Factory setting)
AUTO FF=ON Turn on the auto form feed. Every time data
remains in the printer’s memory, the auto
form feed takes place after the wait time set
as below.
When you turn on the auto form feed as above, you need to set the wait time
in the following sub-setting menu:
Display Message Wait Time
WAIT TIME= 1s Set the wait time for the auto form feed.
. The printer automatically prints out the
. remaining data after the set wait time.
WAIT TIME=99s The wait time can be set from 1 to 99
seconds.
■ Form Feed Suppress
You can turn on or off the form feed suppress function in this mode menu as
follows:
Display Message Form Feed Suppress
FF SUPPRESS=OFF Turn off the form feed suppress function.
(Factory setting)
FF SUPPRESS=ON Turn on the form feed suppress function.
If pages contain no print data, the printer would normally print blank pages.
When you turn this function on, you can suppress printing blank pages.
When the printer is used in the network environment, it may print a blank
page at the end of each print job. When you turn on this function, the printer
does not print blank pages.