Heidolph Synthesis 1 - Manual (Page 90)

90
E
Cursor
9.3 Start / Stop heater
Heater is turned ON / OFF with Start Stop Heater key. In ON mode,
a green LED turns on.
9.4 Set / edit parameters
Value / Speed rotary knob sets / edits parameters. "act "
displayed, shaking frequency is changed; set displayed, edits a
parameter marked with an arrow key. Rotate knob clockwise to
increase, counter clockwise to decrease.
Values so set are saved automatically.
9.5 Set or display
Act / Set key is used to select between display mode and set mode. Display
mode is marked act in display, set mode displays set (set value)
9.6 Select value
A value to be edited in “Set“ mode is marked by cursor. Cursor is
moved with two Select keys.
In “Set“ mode, cursor is moved with Select W
key from zone 1 to zone 2-3-4-
Timer-Speed etc.;
and vice versa with Select X key.
In “Set Ramp“ mode, cursor is moved with Select W
key from No to zone – Temp Step 1 - Time Step 2 –
Temp Step 2 etc.,
and in opposite direction with Select X. key.
9.7 Set temperature gradient
Set Ramp key is used to set one or more temperature gradients
9.8 Activate temperature gradients
Ramp Active key activates a certain temperature gradient.
9.9 Identic
Identic key harmonizes 4 ea. temperature zones (all four are set to same
temperature), such value being transmitted from zone 1 to the other zones.
When programming temperature gradients, Identic key sets temperature
gradient of all of the 4 heater zones.