Heidolph ROTAVAC Vario pumping unit User Manual

Rotavac vario pumping unit instruction manual

Text mode
Original mode

page 1 of 61

Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully

the validity of this document with respect to his product. Manual-no.: 999248 / 28/04/2011

ROTAVAC vario Pumping unit

Instruction manual

Table of contents

Document Outline

Reset / Language selection
Safety information!
- 1.1 General information
- 1.2 Intended use
- 1.3 Setting up and installing the equipment
- 1.4 Ambient conditions
- 1.5 Operating conditions
- 1.6 Safety during operation
- 1.7 Maintenance and repair
2 Standard items and options
3 Technical data
- 3.1 Gas inlet temperatures
- 3.2 Wetted parts
- 3.3 Pump parts
4 Use and operation
- 4.1 Using a ROTACOOL reflux cooler
- 4.2 Installing in a vacuum system
- 4.3 Condensate cooler (accessory)
- 4.4 During operation
- 4.5 Attention: Important notes regarding the use of gas ballast
- 4.6 Shutdown
5 Controller
5.1 Menu guide
5.2 Function Pump down
5.3 Function Vac control
5.4 Function Auto mode
5.5 Function Program
- Example for use
5.6 Function VACUULAN
5.7 Examples for use
- 5.7.1 Vacuum for filtration and suction
- 5.7.2 Vacuum for gel dryer, drying chambers and vacuum concentrators
- 5.7.3 Vacuum for distillation and evaporation (e. g. rotary evaporator)
- 5.7.4 Vacuum for VACUU•LAN networks
5.8 Function Configuration
6 Readjustment of the controller
7 Interface parameters
- 7.1 Setting of the interface
- 7.2 Read commands
- 7.3 Write commands
8 Assembling the condensate cooler (accessory)
9 Troubleshooting
10 Cleaning the pressure transducer
11 Replacing diaphragms and valves
- 11.1 Cleaning and inspecting the pump heads
- 11.2 Replacing the diaphragm
- 11.3 Replacing the valves and assembly of the pump heads
- 11.4 Replacing the overpressure safety relief device at the condenser
12 Warranty, liability, copyright
13 FAQ / repair work
14 Confirmation of condition of unit