Heidolph Automatic Module Distimatic - Manual (Page 43)

Start-Up Start-Up
84 85
All parameters of the following table are not settable and cannot be operated.
Parameter Description
AI:
1: 00000
2: 01000
3: 00253 Switching state of the device inputs and outputs.
Please refer to the 6 switching states in the following menu
overview screen.
ESC+C.. Escape key
To open the menu, press the down arrow key.
To navigate within the menu, press the right/left arrow keys.
To leave the menu, press the up arrow key.
Changing the parameter settings
Navigating between parameter settings
Press the parameter key. The menu opens.
Choose individual parameters with the up/down arrow keys.
Press the set key (for at least 2 seconds). In the display, the flashing cursor
underscores the first digit/character of the parameter setting.
Press the apply key. In the display, the flashing cursor highlights the complete first
digit/character in black color.
Change the parameter settings using the up/down arrow keys.
This applies to all parameter settings except for On or Off:
Navigate to the next digit/character with the left/right arrow keys and adjust these
as described in the previous step.
In order to save the changed parameter settings, press the apply key (minimum of
2 seconds). In the display, the flashing cursor underscores the first digit/character of
the parameter setting.
Press the set key (minimum of 2 seconds) until the previously flashing cursor no
longer underscores the first digit/character of the parameter setting.
To exit the parameter menu, press the parameter key.
Some parameters have multiple options for settings, see, for example, the parameter
endprocess parameter … with the parameter settings empty and delay. Proceed as
follows to choose individual parameter settings.
Press the set key (for at least 2 seconds).
Navigate between individual parameter settings with the Left/Right arrow keys.
Press the apply key to highlight the first digit/character of the parameter setting
selected with the cursor.
Please refer to the sub-section „Changing the parameter settings”.
Setting date and time
Date and time update
When the device is switched off, date and time will be automatically
updated for up to 80 hours. As soon as this time period is exceeded, date
and time must be set again.
An operating state or a message (except for error codes) is shown in the display.
Press the down arrow key. Date and time appear in the display.
Press the set key (for at least 2 seconds). The cursor > highlights the parameter
stop.
Press the down arrow key until the cursor highlights the parameter set.
Press the apply key. The cursor highlights the parameter clock.
Press the apply key. The cursor highlights the parameter set clock.
Press the apply key. In the display the date and time display format appears. You can
now change the setting.
In order to change individual parameter settings, press the up/uown arrow keys.
In order to navigate between parameter settings and rows, press the left/right
arrow keys.
In order to save the new date and time parameter setting, press the apply key.
To exit the parameter menu again, press the set key several times until date and
time appear in the display.