Heidolph Automatic Module Distimatic - Manual (Page 31)

Installation Installation
60 61
Multiple switched socket:
Connect Hei-VAP, chiller and residue pump (only on Distimatic including automatic
drainage of residue) to the connections (20) of the multiple switched socket (total
output = 3500 W).
Connect power cord (22) to the mains socket.
Connect the control cable (19) of the switch unit to connection (21) on the multiple
switched socket.
Control box:
Connect connector (23) belonging to the switch unit to connection (24).
Connect the vacuum pump to connection (25).
Connect all the control cables according to their assignments to connections (26) (see
chapter entitled „Explanation of the components” - „Distimatic in general”).
Connect control box power cord to connection (27).
Connect the control box to the mains socket.
19
22
23
27
25 26
24
21
20
Hei-VAP Industrial Distimatic
WARNING Hazardous materials and solvents!
There are risks posed by the leakage of hazardous substances and
solvents from locations that are not properly sealed.
Check whether all screw caps have been tightened properly at the
threads to seal them off.
Check the device components for hazardous substances and
solvents.
Ensure that the separator for the power supply is easily accessible at
all times.
Cut off PTFE tubes, which are routed through an overflow sensor and
the multiple screw connection, with a cutting knife only at an angle
of approx. 45°. When securing PTFE tubes to a connection, only cut
them vertically with the HOLEX hose cutter.
WARNING Glass breakage!
Serious injuries due to shattering glass and glass breakage.
Check glass devices for damage (breakage, cracks etc.).
Only use glass equipment in perfect condition.
Monitor pressure conditions in the glass attachment.
Work carefully.
If you use other cutters, there is a danger that the
affected tube circuit could leak as a result of crushing
the tube.