Condenser, Cover, Distributor – Heidolph Automatic Module Distimatic User Manual
Page 32
Installation
Installation
62
63
Remove the clamping unit (1) at the condenser.
Loosen thumb screws (2) on reverse side of protective cabinet and slide consoles (3)
upwards with the condenser.
Secure thumb screws (2) so they are hand-tight in this position.
Condenser
1
3
3
2
2
3
Cover
Detach cover (4).
Remove screw connection at distributor.
Remove the clamp at the distributor.
Remove the distributor.
Distributor
(only on Distimatic including automatic drainage of residue)
See also other documents in the category Heidolph Equipment:
- Hei-VAP Precision (59 pages)
- Hei-VAP Value (84 pages)
- Rotacool Mini (104 pages)
- Rotacool (15 pages)
- RotaChill (37 pages)
- ROTAVAC valve control (188 pages)
- ROTAVAC valve control (174 pages)
- ROTAVAC vario control (34 pages)
- ROTAVAC Vario pumping unit (61 pages)
- LABOROTA 4000 eco (168 pages)
- LABOROTA 4000 up to 4003 (364 pages)
- Heating bath HB 4000 (52 pages)
- LABOROTA 20 eco (180 pages)
- LABOROTA 20 compact and safety (284 pages)
- LABOROTA 20 automatic (190 pages)
- ROTAVAC 20 (35 pages)
- Synthesis 1 (268 pages)
- MR Hei-Standard (39 pages)
- MR Hei-End (124 pages)
- MR Hei-Mix L (24 pages)
- MR Hei-Mix S (34 pages)
- EKT Hei-Con (78 pages)
- Heat-On (13 pages)
- StarFish Multi-Experiment Work Station (17 pages)
- RZR 1 (44 pages)
- RZR 2020 (58 pages)
- RZR 2051 control (68 pages)
- REAX top (44 pages)
- REAX 2 (48 pages)
- REAX 20 (54 pages)
- Multi Reax (60 pages)
- TITRAMAX 100 / 101 / 1000 (60 pages)
- UNIMAX 1010 (68 pages)
- UNIMAX 2010 (72 pages)
- Incubator 1000 (64 pages)
- Pump drives (198 pages)
- SilentCrusher M (146 pages)
- SilentCrusher S (98 pages)