EZWatch Evolution - Manual (Page 48)

3.3 Encoding Option
3.3.1 Pre-record/ Post-record Time
The pre-record/ post-record function saves the recording data accordingly. For instance, to set up a 5
second pre-record time means the system will start saving the recording data 5 seconds before the event
happens.
Note: The maximum of pre-record/post record period is 60 seconds.
3.3.2 Record Mode
Always Record:
Select this option to record the video continuously.
Record on Event: * Some options are not available under Lite License
Select this option to obtain the “Select Event” panel. From the Smart Guard list,
check the camera events or digital inputs to trigger the recorded action. Click OK.
Note: Please note it is required to enable ”Smart Guard” from the Main Console
panel before configuring “record on event” to trigger recording.
Record on Motion:
Select this option to start recording when motion is detected. Adjust sensitivity, the
frame interval and zone to setup motion detection. To setup a single detection
zone, left-click and drag the mouse to draw a rectangle. To setup more than one
detection zone, simply repeat the same process or click “All” to select the entire
screen.
Note: The maximum number of rectangle detection zones is 10.
3.3.3 Encoded Options
This option sets up the quality of the recorded video. The “Original Video” window
is the original stream from the camera. The “Encoded Video” is preview of the
recorded video corresponding with the encode settings below.
For IP cameras
The Encode Video function will reduce frames or re-encode original streaming from
Original Video Encoded Video
Video Encoder Record Mode Time Option