Det-Tronics UD10 DCU Emulator FlexVu Universal Display Unit - Manual (Page 14)

12 95-8656 4.2
Enter the appropriate data on the DCU Editor Screen.
See Figure 5. The units and range entered at S3 will
be seen in S3 and the Controller, but are not sent to the
UD10-DCU. It is the user’s responsibility to ensure that
S3 matches the actual detector type.
The alarm and calibration gas setpoints are downloaded
to the UD10-DCU.
The LON parameters can be checked at the UD10-DCU
display under the “LON Config” menu.
Display Status
General Info
Fault/Status
LON Config
History
Display Info
Debug Menu
LON Config
Hgh Alarm Level
Low Alarm Level
Cal Gas Conc
Status Rate
Lon Address
Main Menu
Process Vars
Display Status
Device Status
Display Setup
Device Setup
Device Cal
Display Test
Device Test
Figure 5—DCU Editor Screen