Det-Tronics GTS Sensor Module SAFETY MANUAL - Manual

SAFETY MANUAL
Electrochemical Toxic Gas Detector
GT3000 Series
Includes Transmitter (GTX)
with H
2
S or O
2
Sensor Module (GTS)
1.1 © Detector Electronics Corporation 2012 Rev: 3/12 95-8685
SAFETY CERTIFIED GT3000 SERIES
ELECTRoChEMICAL ToxIC GAS DETECToR
This manual addresses the specific requirements and
recommendations applicable to the proper installation,
operation, and maintenance of all Safety-Certified
(SIL-Certified) GT3000 Electrochemical Toxic Gas
Detector product versions. For complete information
regarding system overview, performance, installation,
operation, maintenance and specifications of the
GT3000 Series, refer to instruction manual 95-8616.
QUALITY PoLICY STATEMENT
All quality assurance control measures necessary for
safety management as specified in IEC 61508 Part 1
have been implemented. The quality management
system of Det-Tronics is based on the requirements
of EN ISO 9001 and ANSI/ASQC Q9001 through the
application of the United Technologies Company
Achieving Competitive Excellence (ACE) program. In
addition, the Quality Management System complies
with the European ATEX Directive requirements per EN
13980, the International Electrotechnical Commission
requirements per OD005/V2, and the supervised
testing requirements per ISO 17025.
SAFETY MESSAGES
Procedures and instructions in this section may
require special precautions to ensure the safety of
personnel performing the operations. Information that
raises potential safety issues is indicated by the word
“Warning”. Always read and understand these safety
messages.
WARNING
The GT3000 Electrochemical Toxic Gas Detector
is intended for use in hazardous environments
that may include explosive levels of flammable
gases and vapors. This product must be properly
installed, operated and maintained. Improper
installation or use could result in an explosion or
fire resulting in death or serious injury.
• Do not remove the cover of a junction box in
explosive environments when device power is
on and circuits are live.
• Device must be properly installed to meet
hazardous area explosion-proof/non-incendive
and intrinsic safety requirements.
Sensor
Module
(GTS)
Transmitter
(GTX)
Detector (GT3000)