Eppendorf InjectMan 4 - Manual (Page 81)

Troubleshooting
InjectMan ® 4
English (EN)
81
7.2.2 Error
WARNING 5 • Z-module is not connected.

Switch off the device.

Connect the plug of the
Z-module to the control
board and tighten.

Switch the device on.
WARNING 6 • Synchronization error with
FemtoJet during an
injection.

Set another synchronization
for
Synchr. inject. .

Set the synchronization
IMMEDIATE , LIMIT or
PRESSURE .
Symptom/message Cause Remedy
ERROR 10 – ERROR 99 • Technical error.

Switch the device off and
back on.

Reset the parameters to the
factory settings.

Contact Eppendorf Service.
Symptom/message Cause Remedy