Eppendorf InjectMan 4 - Manual (Page 38)

Installation
InjectMan
® 4
English (EN)
38
4.12 Connect the motor module to the control board
2. Rotate the angle head by 180°.
3. Push the knurled screw onto the spindle
end and fasten it with the set screw.
4. Turn the knurled screw until the desired
angle is set.
WARNING! Risk from incorrect supply voltage

Only connect the device to power supplies which correspond with the
electrical requirements on the name plate.

Only use sockets with a protective earth (PE) conductor and suitable power
cable.
NOTICE! Damage to the control board as a result of incorrect handling.

Grasp the control board on the housing.

Do not lift the control board using the joystick.

Never place the control board on the joystick.
+