Eppendorf InjectMan 4 - Manual (Page 53)

Operation
InjectMan ® 4
English (EN)
53
6 Operation
6.1 Switching the device on or off
6.1.1 Switching on the device
1. Switch on the device at the mains power switch.
• The motor module and the control board are switched on.
• The device runs through an initialization phase.
• The application screen will appear.
6.1.2 Switching the device off
1. Switch off the device at the mains power switch.
The motor module and the control board are deenergized.
6.2 Activating or deactivating the control board
6.2.1 Activating the control board
Prerequisites
• The display shows STANDBY .
1. Press the standby key.
• The keys, joystick, selection dial and softkeys are activated.
• The display shows the application screen.
6.2.2 Deactivating the control board
The step motors slowly move to the next parking position. This prevents the motors falling
back to the parking position and the capillary jumping.
1. Press the standby key.
• The keys, joystick and selection dial are deactivated
• The display shows STANDBY .
WARNING! Electric shock due to damage to device or mains cable.

Only switch on the device if the device and mains cable are undamaged.

Only use devices that have been properly installed or repaired.

In case of danger, disconnect the device from the mains supply by pulling the
power plug from the device or the mains socket or, by using the isolating
device intended for this purpose (e.g., emergency stop switch in the
laboratory).
Do not move the joystick immediately after power-on. Wait until the initialization
is completed. The completion of initialization is indicated by the display
switching to the operating state.