Eppendorf InjectMan 4 - Manual (Page 78)

Operation
InjectMan
® 4
English (EN)
78
6.20.2 Execute the Selftest function
1. Select Selftest and confirm with Enter .
2. Confirm Execute with Enter .
The screen for the Selftest function appears.
3. Execute Selftest with Start .
The motors move up to the limit stops.
4. Terminate Selftest with Stop .
6.21 Resetting parameters to the factory settings
6.21.1 Perform reset
Reset all parameters to the factory settings.
1. Keep the home key pressed.
2. Switch on the device at the mains power switch.
The screen for GENERAL RESET appears.
3. Execute the function with Yes .
• All parameters are now reset to the factory settings.
6.21.2 Carrying out a reset in the menu
Prerequisites
• An application has been selected.
1. Press the menu key.
2. Select the Function menu.
3. Press Enter .
4. Select User default and confirm with Execute .
• All parameters are now reset to the factory settings.
6.22 Remote computer control of the InjectMan 4
You can control the InjectMan 4 by means of a terminal program remotely via computer.
Computer control by means of a terminal program is only recommended for certain
applications and is not described in this operating manual. A special operating manual for
this functionality is available at the following Internet address: www.eppendorf.com.
CAUTION! Risk of crushing between the modules
The modules automatically move in all spatial axes.

Do not reach into the movement range of the modules.
Eppendorf does not provide any support for controlling the InjectMan 4 by
means of a terminal program.