Eppendorf InjectMan 4 - Manual (Page 44)

Installation
InjectMan
® 4
English (EN)
44
4.14.3 Connecting the Computer
Prerequisites
• A data cable is available.
• Devices are switched off.
1. Connect the data cable to the port for external devices.
2. Connect the computer to the data cable.
3. Switch on the control board.
4.14.4 Connecting two devices
Prerequisites
• Y-connector is available.
• Devices are switched off.
Two devices can be connected with a Y-connector.
The following combinations are possible:
• Computer and FemtoJet
• FemtoJet and PiezoXpert
1. Connect the Y-connector to the port for external devices.
2. Connect the device combination.
3. Connect the devices.
• After initialization, status messages appear on the application screen.
Control with a computer is described in the Cell Technology · PC Control
manual.