Eppendorf XplorerPlus - Manual (Page 42)

Eppendorf Xplorer® (plus) — Operating manual
42
5.16 Pipetting with fixed volume (Fix dial setting)
Previously stored programs with fixed volumes can be executed in the Fixed volumes (Fix) mode.
Up to 10 different pipettings can be created (see Editing (Edit dial setting) on p. 39). 3 fixed
volumes are predefined upon delivery:
• 10 % of the nominal volume
• 50 % of the nominal volume
• 100 % of the nominal volume
The aspiration speed and dispensing speed are displayed to the right of the fixed volume.
Requirement
• Pipette switched on (see p. 19)
• Fixed volumes (Fix) operating mode selected (see p. 42)
• Pipetting with fixed volume created (see p. 39)
• Pipette tip attached (see p. 24)
1. Select the pipetting using the rocker.
2. Press the
Select softkey.
3. Press the rocker up to aspirate liquid.
4. Press the rocker down to dispense the liquid.
5. Press the rocker downward after the dispensing to execute the blow-out (
Blow ).
5.17 Option (Opt dial setting)
You can set the following options, which apply to all operating modes in the Option mode.
Requirement
• Pipette switched on (see p. 19)
• Option operating mode selected (see p. 33)
1. Select the option using the rocker.
2. Press the
Select softkey to open the option.
3. Change the option using the rocker.
4. Press the
End or Back softkey to exit the option.
5. Turn the selection dial to an operating mode to exit the options and to continue with
dispensing operations.
5.17.1 General help
This describes the elementary steps for all modes. This option does not contain any adjustable
parameters. The help texts in the Xplorer are not a substitute for reading the operating manual.
Only available for the Xplorer plus pipette
Hint!
 Press the Help softkey to display information on the selected option.
5
Operation