Eppendorf XplorerPlus - Manual (Page 17)

17
Eppendorf Xplorer® (plus) — Operating manual
4.3 Charging the rechargeable battery
Recharging the rechargeable battery
1. Insert the assembled power supply (order number 4986 603.005) into a power outlet.
2. In the Xplorer pipette check whether a rechargeable battery is inserted and connected.
3. Insert the charging plug of the power supply into the connector socket of the Xplorer pipette.
The display briefly shows the connection with the power supply. The charging process is
indicated by a flashing rechargeable battery symbol in the display. If the rechargeable battery
is almost completely discharged, the display will only switch on after a slight delay.
4. Switch on the ON switch to observe the charging process.
The pipette can be charged in both switch settings.
5. Charge the rechargeable battery for at least three hours.
The rechargeable battery will only achieve its full capacity after several discharge/charge
cycles.
WARNING!
Incorrect or damaged power supplies can lead to severe person injury or damage to the
device.
Incorrect or damaged power supplies can cause electric shock or cause the device to overheat,
catch fire, melt, short circuit or cause similar damage.
 Only use the supplied power supply for charging the device. The correct power supply unit is
indicated via the Eppendorf logo and the device name on the power supply.
 Do not use a damaged power supply.
NOTICE!
Loss of full rechargeable battery charging capacity if charged incorrectly.
The supplied rechargeable battery is not charged completely. If the rechargeable battery is not
charged completely before it is used for the first time, its charging capacity will remain
permanently greatly reduced. The rechargeable battery will only achieve its full capacity after a
few discharge/charge cycles.
 Charge the rechargeable battery for at least three hours before it is used for the first time.
 Do not charge the rechargeable battery in a hot location (>60°C).
 Only charge the rechargeable battery using the supplied power supply.
Hint!
For identification purposes, the power supply contains a sticker with the name of the compatible
devices. The power supply is designed for the 100 V- 240 V range.
Multipette ® stream/Xstream
Repeater ® stream/Xstream
4986 603.005
Xplorer TM
4
Installation