Eppendorf XplorerPlus - Manual (Page 27)

27
Eppendorf Xplorer® (plus) — Operating manual
5.8 Automatic dispensing (Ads dial setting)
In the Auto dispensing (Ads) mode, aspirate liquid and dispense it in uniform partial volumes in
selected time intervals. The reverse stroke and remaining stroke are triggered before or after the
dispensing steps. These additional volumes may result in volume limits when using filter tips
(see p. 43).
Requirement
• Pipette switched on (see p. 19)
• Auto dispensing (Ads) operating mode selected (see p. 33)
• Parameters set (see p. 22)
• Pipette tip attached (see p. 24)
1. Press the rocker up to aspirate liquid.
Then follow the instructions in the display.
2. Press the rocker down to trigger the reverse stroke.
3. Keep the rocker pressed for the duration of dispensing. After the first dispensing step, the
following dispensing steps are triggered with the displayed time interval ( Time ).
After dispensing, decide whether the residual liquid should be dispensed or liquid should be
aspirated again.
 Liquid aspiration: press the rocker up once.
 Liquid dispensing: press the rocker down twice.
Aspiration Reverse stroke Auto dispensing Aspirate or
empty
1 2 3 4 6 5
Hint!
 Press the Empty softkey to cancel dispensing. The tip is completely emptied.
 When you release the rocker, an ongoing dispensing operation is still being completed. The
display shows the possible dispensings under
Steps . Press the rocker again to continue
dispensing.
5
Operation