Eppendorf XplorerPlus - Manual (Page 38)

Eppendorf Xplorer® (plus) — Operating manual
38
5.13.5 Sequential pipetting (Spc dial setting)
In the Seq. Pipetting mode, a maximum of 10 different pipetting volumes are dispensed in a fixed
sequence. This mode is well suited for dilution series. The Seq. Dispensing mode is also well
suited for dilution series. The random error (precision) and systematic error (accuracy) are better
for pipetting than with dispensing. The
Seq. Pipetting mode offers more flexibility with the volume
selection than the Seq. Dispensing mode.
Requirement
• Pipette switched on (see p. 19)
• Seq. Pipetting (Spc) operating mode selected (see p. 33)
• Parameters set (see p. 22)
• Pipette tip attached (see p. 24)
1. Press the rocker up to aspirate liquid.
2. Press the rocker down to dispense the liquid.
3. Press the rocker downward after the dispensing to execute the blow-out (
Blow ).
4. If the piston is in the basic position: press the Back softkey to exit the mode.
Only available for the Xplorer plus pipette
Aspiration Dispensing Aspiration Dispensing
Hint!
 After each dispensing, you can repeat the blow-out ( Blow ) as many times as you would like by
pressing the rocker down.
 Observe the information on the blow-out ( Blow ) (see p. 29).
5
Operation