Apple MainStage 2 - Manual (Page 74)

The available actions appear in the second column of the browser.
Click the Actions folder to
see available actions.
Click the action you
want to map from
the submenu.
4 Select the action you want to map.
Note: If you map a knob screen control to an action to select a patch (such as the
−10 Patches, Previous Patch, Next Patch, or +10 Patches action), the screen control jumps
to the value of the hardware control, regardless of the setting of the Respond to Hardware
Move parameter in the Screen Control Inspector.
Mapping a Screen Control to Multiple Parameters
You can map a single screen control to multiple parameters and control how the screen
control modifies each mapped parameter. Mapping a screen control to multiple parameters
is also referred to as multimapping. You map a screen control to up to eight parameters
by adding mappings in the Screen Control Inspector.
To add a mapping
1 Map the screen control to a parameter or action, as described in Mapping Screen Controls
to Channel Strip and Plug-In Parameters and Mapping Screen Controls to Actions .
2 With the screen control selected, click the Add Mapping (+) button at the upper-right
corner of the Screen Control Inspector.
A new Unmapped tab appears in the Inspector, showing the Parameter Mapping browser.
3 In the Parameter Mapping browser, choose the parameter to which you want to map the
screen control.
If you add a mapping while the Learn process is active (the Map Parameter button is red),
you can immediately learn the new mapping. The Command Editor also includes key
commands for selecting the previous and next tab to make mapping to multiple
parameters easier. For information about using key commands, see
Using the Command
Editor .
74 Chapter 5 Working in Edit Mode