B&K CT600.1 - Manual (Page 74)

B K
&
S B
IMPLY ETTER!
68
Audio / Video Submenu
Zone Power On Settings
Use Left/Right to select a zone to setup for power on set-
tings. Settings that may be configured include audio input,
video input, volume level, bass level, treble level, and EQ
setting. Use Up/Down to select an item to adjust. Use
Left/Right to adjust the item selected.
Settings may be configured for use when a zone is first
powered on. Use the Up/Down on the remote to highlight a
setting to be changed and the Left/Right to change the set-
ting.
Page/Event Setup
Use Left/Right to select which Page/Event to configure.
Then use Up/Down to select an item to adjust and use
Left/Right to adjust the item selected.The zone may switch
to any shared input, change volume or mute volume, etc.
*Note: Only Zones which have been setup under the
Zone(s) Menu to respond to Page/Event 1 or 2 or Both
will be affected by the Setup Page/Event screen.
Page/Events are described on page 45.
Use Left/Right to select which group of zones to set up.
Then use up/down to select changes. Use Left/Right to
adjust between relative and absolute.
Relative: all volumes change relative to one another.
Absolute: All volumes sync to same volume level before
change is made, referenced from the zone the command
is received from.
*Note: The expression "linked zones" means the hard-
ware zones that make up a code-set group (i.e. the logi-
cal zone "Downstairs" may consist of the hardware zones
B - “Dining Room”, C - “Kitchen”, and D - “Patio”).