B&K CT600.1 User Manual

Page 53

B K

IMPLY

ETTER!

Page / Event - Tab 7

3. Level:

Set the volume desired for the Page/Event. When the event is triggered, the volume will be switched to this
level in the zones set to respond to the Page/Event. Built in intelligence "remembers" the previous state of
the zones before the Page/Event occurred; therefore, it will return the zones to their previous state once the
Page/Event is finished.

4. Turn Off Delay:

Adjust the time for which the Page/Event will remain on. If a voltage is momentarily sensed, the Page/Event
will last for the time selected. The Page/Event will stay active as long as a voltage is preset, the timer starts
from the time the voltage is dropped. Use Forever (slide bar all the way to the right) if you don't want the
event to end until the user manually selects a new input or a new volume setting. If audio/video sensing is
used, adjusting the delay will affect how long the CT Receiver will wait once the signal is lost.

5. Page/Event Affects Control Out and Flasher Outputs:

Yes - When the event activates, the flasher outputs will change their routed location to the output
designated by the page/event input selection. Control outputs would also be triggered for specified
inputs.
No - The control and IR flashers will stay in the last selected state. Thus, if the client were just watch-
ing a DVD, they may still use the DVD remote to pause the DVD. By default, Event Flasher Output is
set to no.

6. Page Event 2:

Sets up in the same way as Page/Event 1.