B&K CT600.1 - Manual (Page 13)

Screen Title - Displays a custom title edited from the LCD button editor. Under
default programming it will display “Main”.
Accessories Guide
B K
&
S B
IMPLY ETTER!
7
The CK1.1 Keypad Front Panel/Back Panel
Page Button press to display
any additional pages of func-
tions.
LCD Buttons -
Names on the screen
change depending on what
function is programmed on
the button. For Example, if
page 1 holds all controls for
the CD player the LCD but-
tons will display Play, Stop,
etc. so the device (CD in
this case) may be con-
trolled.
Backlight Button lights the keypad
display and also recalls status
feedback for that zone. Status
feedback will display input, radio
station, volume, bass, treble and
loudness levels.
Remote Control IR Receiver
conceals an IR (Infrared) Sensor
which relays commands from hand
held IR remote control to the main
unit and components connected to
flashers.
Power LED lights up when this
Zone/Room is ON. (Controlled
by the 12V Control)
Up, Down and Mute Controls
may be programmed for Volume and
Mute control for the B&K zone or any
device.
Programming Jack - Behind the Faceplate
Four tabs hold the faceplate to the keypad chassis. To remove the faceplate, simply pull the faceplate off the keypad chas-
sis. Once removed, the Programming Jack is revealed. Note: When testing keypad functionality, remove the programming
jack. The keypad will not receive RS-232 communication while the programming jack is plugged in.
Master [IN]
The RJ-45 Master [IN] is used for the home
run back to the CT Receiver. RJ-45 termi-
nation allows the use of CAT-5 cable to be
used for keypad installation. See Page 19 Slave [OUT]
Used when running multi-
ple keypads in one zone or
daisy chaining additional
zones.
IR OUTPUT
The IR Output may be used to con-
nect an emitter directly from the key-
pad to a local IR source.
sold separately