Konica Minolta bizhub C650 - Manual (Page 109)

C650 5-13
Setting up the PCL driver (Windows) 5
Hole punching
Holes can be punched into the printed document.
2
Reminder
The hole punch function is available only when the punch kit or the Z folding unit is installed with the
optional finisher.
1
Click the Finish tab.
2
Select the "Punch" check box.
3
From the drop-down list, specify the number of punched holes.
2
Note
The hole-punch position changes according to the binding position specified from "Binding Position".
The number of punch holes that can be selected may vary depending on the punch kit that is installed.
Folding
You can specify to fold a printed document.
2
Reminder
The Half-fold function and Tri-fold function are available only when optional finisher FS-608 is installed.
The Z-fold function is available only when the Z folding unit is installed with the optional finisher.
1
Click the Finish tab.
2
Select the "Fold" check box.
3
From the drop-down list, specify the folding condition.
2
Note
The Half-fold function or Tri-fold function cannot be specified when the staple, punch, or Center Staple
and Fold function is specified.
The Z-fold function cannot be specified when the Center Staple and Fold function is specified.
To use the Z-fold function, set the "Paper Size" setting of the application software or printer driver to
the paper size value indicated in the setting (Z-Fold (A3, B4, 11 × 17, 8K)/Z-Fold (8-1/2 × 14)) that is
selected from the drop-down list.
Specifying the output tray
You can specify the tray to which the printed document is output.
1
Click the Finish tab.
2
From the "Output Tray" drop-down list, specify the output tray.