Konica Minolta KIP 7000 - Manual (Page 202)

Section 6 Request 6-46
AutoRecognize=c:\programs\DS\MAD.exe
PowerScriptExe=c:\programs\DS\pscript.exe
KipPortExe=C:\Programs\KawPDFT.Exe
RecallDir=C:\Programs\Recall
TempDir=C:\Programs\TR
MiniSize=1000,720
Units=ENGLISH (English or Metric units)
AddHpglCmd=
Values are software switches, used to apply custom commands to HPGL/2
files. This line may contain one switch, multiple switches, or none. Some
switches are specific to certain versions; some are specific to certain printer
models. Switches are case-sensitive. Some switches have a value after the
switch, separated by a space. Multiple switches are separated by a space.
You may see some of the following:
-D 300 Forces raster images to 300 DPI, to compensate for raster images
looking ‘squished’ or out of place on some files created with HP
drivers.
-G Affects grayscale level of embedded raster images. This feature is
now built into the Request Pen Table. Value (1-100)
-Y KIP 8000-specific.
-Z KIP 8000-specific.
An example of how multiple switches might appear in the line:
AddHpglCmd=-D 300 –G 50
DebugVal=999
Used for diagnostic purposes only.
MP=а‘Ю •аƒ„—…000000
The encrypted master password as set by the installer
ST=00