Konica Minolta KIP 7000 - Manual (Page 100)

3-5 Section 3 ?” Screen
2.1.2 Total Run
This meter counts the total number of linear meters run on the printer in all countries. One
count = one linear meter
2.1.3 Meter B
This counter can be reset at any time to count the units in a particular job. The date of last
“reset” is also displayed. This counter’s units are the same as Meter A. Press the reset
button to start at “0”
2.1.4 Scan Count
The Scan Count displays the total count of the “imaged” area. If the original was larger than
the saved imaged area only the saved imaged area is recorded. If the incorrect original size
was selected the selected size will be recorded.
Example:
With a 24x36 original
1) If the original was feed 36” wide with a 36” wide setting on the User Interface
then 6 sq ft recorded.
2) If the 36” wide original was scanned in at a 24” wide manual setting, the size
will be recorded as 24x24 or 2 square feet.
2.1.5 Scan Count- Temp
This counter can be reset at any time to count the units in a particular job if so required.
The date of last “reset” is also displayed. This counter’s units are the same as in Scan
Count. Press the reset button to start at “0”
2.1.6 Software version
Displays the software IPS version for technical support
2.1.7 Firmware Version
Displays the printer firmware version for technical support
2.1.8 IPS Number
Displays the current IPS number, this is required for any optional upgrades to the KIP 7000.
2.1.9 Machine Serial Number
Displays the KIP 7000 hardware serial number, this is also located on the lower rear of the
printer.
NOTE
The units of this counter are taken from the internal processor of the printer and
can be “reset” if care is not taken upon replacement of the DC Controller.
Please see KIP 7000 Service Manual for details on the setting procedures.
In case of discrepancies: The hard counter shall be taken as the correct value!
NOTE
If this serial number differs from the “hard coded” number on the lower rear of
the printer contact your local service company! The hard code serial will be
taken as correct in the case of any discrepancies.