Konica Minolta bizhub PRESS 2250P - Manual (Page 121)

Parameter Option Description
○ Sets per sheet—Enables you to select the number of sets of
the job to print on the defined printable area.
○ Stacking mode for VDP—For VDP jobs only. This option
enables you to print two or more different booklets on the
same sheet. The booklets are arranged in the cut-and-stack
method.
○ Nested Saddle - Sheet per group—A book-finishing
technique that combines the saddle-stitch imposition method
and the perfect bound imposition method. As with saddle
stitching, pages are grouped together and stapled or stitched
across a common center fold. The saddle groups are then
stacked one on top of another and glued, as with perfect
binding.
● Folded Signature—A technique in which a large sheet is folded
several times to form a section of a book, a magazine, or a
pamphlet.
Preview Enables you to view either a thumbnail view or a layout view of your
imposition layout and settings. You can open the Preview window at
any time and keep it open to check your imposition settings as you
select them. The Preview window dynamically reflects any changes
that you make.
Size Trim size The size of the finished, trimmed document. For custom trim sizes,
you must specify a width and height.
Tip: If you set the trim size smaller than the page size set in the
DTP application, the data will be cropped. Setting a larger trim size
results in a larger border on the printed page.
Trim
orientation Displays the orientation, portrait or landscape, for the selected trim
size. If the wrong orientation is selected, the job might be cropped
as a result.
Preview Enables you to view either a thumbnail view or a layout view of your
imposition layout and settings. You can open the Preview window at
any time and keep it open to check your imposition settings as you
select them. The Preview window dynamically reflects any changes
that you make.
Templates Layout Provides the following options:
● Custom—Enables you to specify how many pages to place
horizontally (Rows) and vertically (Columns) in a custom layout.
Note: Templates that are created or imported via the Imposition
Template Builder are also available.
● Best Fit—Automatically calculates the most suitable number of
columns and rows.
Note: This option is not available for the saddle-stitch and
perfect bound imposition methods.
Imposition tab in the job parameters window 113