Konica Minolta bizhub PRO 2000P - Manual (Page 87)

87
Manually park the Shuttle
[45]
Result
The error message ‘MANUALLY PARK SHUTTLE’ is cleared from the screen.
The shuttle axis re-references and the message ‘Shuttle axis moving’ is displayed.
When the message list is clear, you can continue operation
Step
1 Open the folder cover. Open and Close the Folder Cover
on page 37
2 Push the shuttle-assembly to
the right. figure 45 on page 86 shows the
correct position for the shuttle
assembly.
If the shuttle assembly does not
move to the correct position, push
the pick-up fingers away from each
other by 2-3mm and try again.
Repeat if necessary.
3 Wait until the error message
‘SHUTTLE NOT PARKED’
is cleared from the screen. If the message does not clear, check
that the shuttle assembly is in the
correct position. Repeat Step 2 if
necessary.
4 Close the folder cover.