Konica Minolta bizhub PRO 2000P - Manual (Page 110)

110 Chapter 6 Maintenance
Install New Stitch Wire
Install the Stitch Wire into the Stitch Head
[65]
Close the Booklet maker
[66]
Step Action Information
1 Pull the stitch wire from the
end of the stitch wire guide.
2 Make sure the stitch wire runs
behind the gas-strut. [71]
3 Feed the end of the stitch wire
between the felt
wire-cleaning pads. [72]
Detail A: Felt Wire-Cleaning Pads
4 Push the stitch wire into the
stitch wire guide block. [73]
Push stitch wire in direction of arrow
5 Push the stitch wire as far as
possible. [74]
Detail A:Make sure the stitch wire runs
between the wire feed rollers and into
the middle wire tube.
A
A
Step Action Information
1 Close the stitch-wire cabinet.
2 Lower the Booklet maker
main deck. ( see ‘Lower the Clincher Frame’ on
page 39 ).
3 Lower the clincher frame.