Konica Minolta bizhub PRO 2000P - Manual (Page 76)

76 Chapter 5 Error Conditions, Problems, and Solutions
Stitch Head Problems
Stitch Head Problems
[37]
Problem Cause Solution
The stitch head does not
operate The STITCH function is
not selected. Make sure STITCH is set
to 1 or more (
see ‘The
BASIC Window’ on
page 25
).
The stitch wire is
finished. Load a new spool of
stitch-wire (
see ‘Install
New Stitch Wire’ on
page 107
).
The stitch wire is
jammed. Clear the jammed stitch
wire (
see ‘Clear a Stitch
Wire Jam’ on page 77 ).
The stitches are broken There is stitch wire
jammed in the stitch head. Inspect and remove the
jammed stitch wire (
see
‘Clear a Stitch Wire Jam’
on page 77
).
The stitch wire is jammed
on the spool The stitch wire spool is
not installed correctly. Check and correct ( see
‘Fit a New Stitch Wire
Spool’ on page 108
).