Konica Minolta bizhub PRO 2000P - Manual (Page 10)

10 Chapter 1 Introduction to the Booklet maker
The Rear Panel of the Booklet maker
The Rear Panel of the Booklet maker
Illustration
[3]
[3] The Rear Panel of the Booklet maker
Component - function table
[3]
B
C
E
D
F
A
[3] The Rear Panel of the Booklet maker
Component Function
A Rating and serial
label The rating label displays the type of machine, serial
number, power use, and fuse information.
B Power ON/OFF
switch The power ON/OFF switch turns the Booklet
maker ON or OFF. When you turn OFF the Booklet
maker, the current settings are stored.
C Voltage advisory
label The voltage advisory label tells the installer to refer
to the installation instructions before the Booklet
maker is connected to the electrical power supply.
The Booklet maker can be adjusted for one of
several different input voltages.
D Fuses The fuses make sure the operator and the machine
are protected if there is an electrical problem or
short circuit.
E Voltage label The voltage label is fitted to the Booklet maker
during the installation procedure. The voltage label
displays the selected voltage.
F Power input
connector The power input connector is used to connect the
Booklet maker to the electrical power supply.