Konica Minolta bizhub PRO 2000P - Manual (Page 100)

100 Chapter 6 Maintenance
Clean the Trimmings Removal Fingers
[53]
Procedure
[54]
A Trimmings removal fingers
B Drive end of the conveyor shaft
Step Action Information
1 Turn off the Booklet maker
2 Lift the Booklet maker main
deck. The procedure can be seen from the
top of the machine. Access to the
parts is through the former-clamp
mechanism.
3 Remove the trim bin.
4 Clean the visible
trimmings-removal fingers
with an alcohol wipe.
5 Rotate the conveyor shaft by
half a turn. 1. Hold the shaft and push to the
right, against the spring pressure to
disengage the shaft from the drive
pin.
[57]
2. Rotate the shaft by half a turn.
3. Align the shaft with the drive pin
and release.
6 Clean the visible
trimmings-removal fingers
with an alcohol wipe.
7 Install the trim bin.
8 Close the Booklet maker.
1
2
3