beautypg.com

Konica Minolta bizhub PRO 2000P User Manual

Page 83

background image

83

Clear a Stitch Head Jam

[44]

Step

Action

Information

1

Lift the Booklet maker main
deck.

See

Lift the Booklet maker Main Deck

on page 41

2

Remove the wire-holder
from the stitch head.

Move the wire-holder retaining
spring to the right.

figure 42 on

page 81

Remove the wire-holder

If the wire-holder is held in position,
use a screwdriver to help remove the
wire-holder from the stitch head.

[44]

3

Inspect the area behind the
wire-holder for stitch-wire.

figure 43 on page 82

4

Remove any stitches or
pieces of stitch-wire and
clean the area with the air
duster.

Use wire cutters to remove any
jammed stitches or pieces of
stitch-wire.

5

Lubricate the stitch-head.

Lubricate the Stitch Head on
page 102

6

Fit the wire-holder.

Remember to put the wire-holder
retaining spring in position.

7

Close the Booklet maker.

8

Start the Booklet maker.

If the head operates normally and
returns to the parked position, then
further action is not needed.
If the stitch-head remains jammed,
then repeat the procedure again.
If the problem continues, contact
your service engineer.

This manual is related to the following products: