Introduction – Konica Minolta bizhub PRO 2000P User Manual
Page 6
6
Chapter 1 Introduction to the Booklet maker
Introduction
Introduction
Introduction
Thank you for choosing the Booklet maker.
Your Manual
The User Manual for the Booklet maker describes how to perform these tasks:
■
Operate the Booklet maker
■
Find and correct error conditions
■
Perform normal maintenance tasks
Operator training is given when the Booklet maker is installed. To make sure you use
your Booklet maker correctly, read your manual.
The User Manual for the Booklet maker does not describe the operation of the
printer. If needed, refer to your printer user manual.
Safety Information
Safety information is included in the separate “Safety Information Manual.” Read
the safety information before you use your Booklet maker.
Caution:
A CAUTION message tells you that a procedure or operation can
be dangerous. To prevent injury, you must follow the instructions.
Attention:
An ATTENTION message tells you that a procedure or operation can
damage the machine or the product. To prevent damage, you must follow the
instructions.
Installation
Your Booklet maker must be installed by a service engineer. Special knowledge is
needed to install the machine.
Attention:
Connect the machine only to a power supply of the correct voltage with a good
ground connection. The correct machine voltage is shown on the label at the power
supply input on the rear of the machine. If the machine is connected to the wrong
supply, the warranty is voided.