Change the fuses, See ‘ change the – Konica Minolta bizhub PRO 2000P User Manual
Page 85
85
Change the Fuses
Change the Fuses
Introduction
The Booklet maker has two fuses at the power input. If either fuse is blown, the
Booklet maker will not operate.
Required tool
Fuse description: 7A, HRC Quick Acting, F
Attention:
Turn OFF the machine and remove the power supply cable before
you change the fuses. This machine uses two fuses in parallel. To avoid the risk
of fire, replace fuses only with the same type and rating.
Procedure
1.
Turn OFF the Booklet maker.
2.
Disconnect the Booklet maker from the power supply.
3.
Turn one fuse-holder to the left and remove the fuse-holder from the Booklet maker.
4.
Check the fuse.
5.
If the fuse is blown, then replace with a fuse of the correct specification.
6.
Repeat the procedure for the other fuse.
Note:
If the fuse blows again, call your service engineer.