Allied Telesis AT-S65 - Manual (Page 68)

Chapter 5: Working With Line Cards
68
Displaying Basic Line Card Information
The AT-S65 software provides a menu that displays an overview of the
status of all the components in the system.
To view the system status and configuration, perform the following
procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu is shown in Figure 24 on
page 52.
Items 1 through 8 in the Module Status and Configuration Menu
display two groups of information about the line cards:
WDM Side
The status of the WDM (line) side of the line card, that coordinates with
the Line group of LEDs. The columns of information in this section are:
Status
The current status of the line card, which can be one of the
following:
Unknown - No line card inserted.
MISMATCH - The line card in this slot is not the correct line card
designated for the slot.
On - The correct line card is inserted in this slot and the power is
on.
Tx
The status of the transmit WDM port, which can be one of the
following:
Offline - The transmitter is disabled.
Online - The transmitter is enabled.
Rx
The status of the receive WDM port, which can be one of the
following:
Offline - The receiver input power is less than -38 dBm ± 2 dB.
Online - The receiver input power is greater than -38 dBm ± 2 dB.
T_SYN
The status of the synchronization of the TX path, which can be one
of the following:
Off - The data is not synchronized (locked) on a transmit path.