Allied Telesis AT-S65 - Manual (Page 22)

Chapter 2: Basic Parameters
22
Configuring Basic Chassis Parameters
The AT-S65 management software provides options to configure some
basic parameters on the chassis. This section contains the following
procedures:
ˆ “Configuring the Chassis Name, Location, and Contact,” next
ˆ “Configuring the IP Address, Subnet Mask, and Default Gateway” on
page 24
ˆ “Configuring the Manager IP Addresses” on page 24
ˆ “Configuring the SNMP Community Strings” on page 25
ˆ “Enabling or Disabling DHCP” on page 25
Configuring the
Chassis Name,
Location, and
Contact
To configure the chassis name, location, and contact, perform the
following procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is shown in Figure 4.
Figure 4. System Configuration Menu
2. From the System Configuration Menu, select System Name and press
Enter.
The name can be up to 20 alphanumeric characters, including spaces
and special characters. To delete a system name without entering a
new name, press the space bar. This name is displayed at the top of
every AT-S65 menu.
System Configuration Menu
System Name: Null (not configured)
System Time Options
Omega Options
IP Parameters
Trap Parameters
Terminal Configuration
Temperature Threshold Configuration
Return to Main Menu...