Allied Telesis AT-S65 - Manual (Page 17)

AT-S65 Management Software User’s Guide
17
Remote Management Session
You can use the Telnet application from any workstation on your network
to manage an AT-LX3800U system. This type of management session is
referred to as remote management because you do not need to be
physically close to the chassis to start the session.
A remote management session allows you to access the same menus and
options that you can access with a local management session.
To manage a chassis remotely, you must first assign an IP address to it,
as described in “Configuring the IP Address, Subnet Mask, and Default
Gateway” on page 24 using a local management session.
Starting a
Remote
Management
Session
To start a remote management session, perform the following procedure:
1. Connect a twisted pair cable to the 10/100Base-T port on the front of
the chassis, as shown in Figure 3.
Figure 3. Connecting a Cable to the 10/100Base-T Port
Note
The RJ-45 port runs in MDIX mode. Be sure to use the proper cable.
The connector and port pinouts are shown in Appendix A, “Technical
Specifications,” the AT-LX3800U Multi-Service Transport System
Installation and Maintenance Guide.
2. In the Telnet application, specify the IP address of the AT-LX3800U
chassis that you want to access.
The software initializes and then the Login prompt is displayed.
3. To configure chassis settings, enter “manager” as the user name. To
only view the settings, enter “operator” as the user name.
TX
CLASS 1 LASER PRODUCT
10/100Base-TX
RS-232
TERMINAL
FT
CO
PA
PB
8
RESET
AT-LX3800U
8
LINE
C
LINE
AT-LX3811/8
SFP
SYNC
TX
RX
LINE
RDY
TX
RX
TRIB RX
100 10
155