Allied Telesis AT-S65 - Manual (Page 33)

AT-S65 Management Software User’s Guide
33
Setting the Temperature Thresholds
You can set a maximum temperature threshold for the chassis, line cards,
and the SFPs in line cards. Whenever a temperature threshold is
exceeded, the chassis sends a trap to the management stations defined in
the Trap Parameters Menu, as described in “Configuring the Trap
Parameters” on page 30. This section contains the following procedures:
ˆ “Configuring the Chassis Temperature Threshold,” next
ˆ “Configuring the Line Card Temperature Threshold” on page 34
ˆ “Configuring the SFP Temperature Threshold” on page 35
Configuring the
Chassis
Temperature
Threshold
To set the chassis temperature threshold, perform the following procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is shown in Figure 4 on page 22.
2. From the System Configuration Menu, select Temperature Threshold
Configuration and press Enter.
The Temperature Threshold Configuration Menu is shown in Figure 9.
Figure 9. Temperature Threshold Configuration Menu
3. From the Temperature Threshold Configuration Menu, select Chassis
Temperature Threshold Configuration and press Enter.
Temperature Threshold Configuration Menu
Chassis Temperature Threshold Configuration
Line Card Temperature Threshold Configuration
SFP Temperature Threshold Configuration
Return to System Configuration Menu ...